Brazen Abbot
Goto Thread: PreviousNext
Goto: Forum ListMessage ListNew TopicSearchLog In
place the floor on the assembled
Posted by: quangongzi (IP Logged)
Date: May 30, 2017 06:44PM

grid line on the ground. (4) fix the beam to the support with a screw and correct the cross beam with a horizontal bar, so that they are on the same plane and perpendicular to each other. (5) place the floor on the assembled transverse beam with a suction plate. (6) if the wall and column edges are smaller than the length of the floor itself, they can be treated by cutting the floor. When cutting, the floor must be measured, so that the cutting good floor can meet and

combined profile on the wall outside the wall and cut the gap between the floor must be in 1.5mm, irregular cutting to match the floor for a column or tube, must be measured accurately to ensure the coordination and the circular floor. At the same time, make sure all the cutting floors must be fixed with the base (if necessary, use extra bases) and keep it level, level and tidy. (7) when laying the floor, level the level with the blister level and adjust the height of the floor

by the support. (8) when a heavy equipment is placed in the engine room, a bracket shall be installed under the floor of the equipment base to prevent the floor deformation. (9) when the movable floor needs cutting, or when the hole is opened, an electric drill is used to punch 6mm~ 8mm holes in the corner of the opening to prevent the veneers from breaking. 5 acceptance standard (1) anti-static anti-static floor and floor surface should be clean, no dust, legacy. (2)

[url=http://customgamedecks@#$%&/composite-deck/covering-a-concrete-patio-with-composite-foundation.html]covering a concrete patio with composite foundation[/url]

[url=http://customgamedecks@#$%&/composite-deck/wood-decking-price-in-singapore.html]wood decking price in singapore[/url]

[url=http://customgamedecks@#$%&/composite-fence/plastic-wood-members-for-outdoor-construction.html]plastic wood members for outdoor construction[/url]

Sorry, only registered users may post in this forum.
This forum powered by Phorum.